Pagina 324 - GC_Sensor_Vision_Safety_Measurement-ENA4

www.datalogic.com
CONNECTIONS
DIMENSIONS
The following operating modes can be
selected via internal dip-switches on the
receiver unit and the SET and calibra-
tion button:
• Scanning with parallel or crossed
beams
• Manual calibration or at powering on
• Absolute 1 or relative 2 measurement
• Absolute 3 or relative 4 detection
• Precise detection or with a
tolerance channel
• Light or dark output
• Sensitivity level
Notes:
1. In this mode, the analogue output is propor-
tional to the last obscured optic
2. In this mode, the analogue output is
proportional to the the total number of
obscured optics
3. In this mode, a certain object in a certain po-
sition in the sensitive area can be detected
through Teach-in. The digital ouput switches
every time the object is in this position
4. In this mode, a certain object can be de-
tected through Teach-in. The digital output
switches each time the object is inside the
sensitive area in any position MODEL a x b (mm) h (mm)
DS3-SD-015 35 x 40 226
DS3-SD-030 35 x 40 376
DS3-SD-045 35 x 40 526
DS3-SD-060 35 x 40 676
DS3-LD-015 35 x 40 226
DS3-LD-030 35 x 40 376
DS3-LD-045 35 x 40 526
DS3-LD-060 35 x 40 676
1 = white = SYNC D-
2 = brown = +VDC
3 = green = NOT USED
4 = yellow = PNP OUTPUT
5 = grey = Analog OUTPUT
6 = red = SYNC D+
7 = blue = 0 V
8 = red = REMOTE TEACH-IN /CALIBRATION
1 = brown = +VDC
2 = white = SYNC D+
3 = blue = 0 V
4 = black = SYNC D-
RECEIVER (RX) EMITTER (TX)